![]() ![]() EDIT: It seems as though the guide button started flashing when I ran the System Report. With the Hyper Drive due Hub, the guide button goes on when I plug in the controller and then dies within a couple of seconds.With the Adam CASA Hub A01, the guide button flashes endlessly. ![]() I have also tested this version of the driver: I am leaving the below comment for history. I managed to get the Wired controller to work with the Adam CASA Hub A01 hub after re-installing 1.0.0-alpha.5, and allowing the developer via security and privacy. I tested with both the Hyper Drive Duo USB-C Hub, as well as the Adam CASA Hub A01. I've had similar issues with a wired Xbox 360 controller on 360Controller 1.0.0-alpha.5. (kernel) Notice - new kext .AppleUSBHostPlatformProperties, v1.2 matches prelinked kext but can't determine if executables are the same (no UUIDs). Personality CFBundleIdentifier differs from containing kext's (not necessarily a mistake, but rarely done): Notice: /Library/Extensions/360Controller.kext has debug properties set. In another issue I saw someone else provided this terminal command result so I figured I'd share it too, ~ % sudo kextutil /Library/Extensions/360Controller.kext And now it won't turn off permanently, lol. I tried the "Enable Driver" option in the Advanced tab. "No devices found." There are no warnings in the System Preferences security pane. The controller will not show up in the preference pane. "No devices found." Detailed Explanation of Issue With 360Controller 1.0.0-alpha.5 the guide button would flash briefly when plugged in. With 360Controller 0.16.11 the guide button flashes endlessly. Vendor ID: 0x045e (Microsoft Corporation) Response of Controller (If you don't know this information, please refer to the README for how to find it. I had previously used this setup in Mojave with no issues. They are connected via a USB to USB-C adaptor. Also tried 3rd party knockoff, same result. Once this is done, the software allows you to check the status of the Xbox 360 controller connected to your. For Windows 8, 8.1, and 10, when you connect the Xbox 360 controller to your PC, the software will automatically install. 360Controller 0.16.11 (preference pane didn't show up)ģ60Controller 0.16.11 Notarized (current install) Connection Method Simply plug in your hardware, install the driver, and your controller will automatically be detected by your PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |